Automatic flush mount electrical enclosure roll forming machine for making wall mounted switchboard enclosures, fetwork box, cirduit breaker enclosures, network enclosure.
Flush mount electrical enclosure machine making dimension.
Push bottom box length is adjustable from 200-600mm, the width is 190mm, and the depth is 80mm. The actual cross-section of the product provided by the customer.
Electrical box roll forming machine for production different type metal enclosure, such as distribution box, flush mount network enclosure, multimedia signal box.
Wall mount circuit breaker enclosure production line parameters of the forming equipment.
a. Power supply: 380V/50HZ/3PH, can customized as per user country.
b. Installed capacity: about 31kw.
c.Forming speed: 0-13m/mind.
d.Shearing method: Servo front shear
e. Drive motor: Unwinder motor 4KW.
leveling motor 2.2KW.
hydraulic punching cutting and hydraulic tensioning motor (two sets) 11KW+7.5KW. forming main engine 5.5KW.
servo motor 2KW
f. Floor area (approx.): length 24m × width 3m (host specification 7mX1.7m)
g Production line direction: from left to right (on the console facing the unit).
h. Equipment color: (customer selection)
i. Superda steel box equipment design can meet 12 hours of continuous production
j. Operating environment
1: Power supply voltage: 380V ± 10% / three-phase four-wire,frequency: 50HZ Total power: about 31KW2: Environment Temperature: 0-40 ° C, relative humidity: 60-95% RH.
https://www.superdamc.com
Flush mount wall enclosure production line process
Uncoiler →Straightening→servo feeder→Hydraulic press breach device → Guide device → roll forming machine → hydraulic punch →shear device (including knife)→ finished product rack
Steel flush mount enclosure roll Forming machine list
Explaination
This production line is equipment for production flush wall mount enclosure. The strip coil to be processed is manually placed on the uncoiler, and then corrected and tensioned. After leveling, it enters the hydraulic pre-punching and punching notch, and is sent to the forming machine by the guide device to form. Under the frictional damping action of the forming roller and pressure roller, after entering the shearing section at a linear speed of 0-10m, the product is cut off as required, and then manually packed away.
